Over 698,000 strictly plumbing related posts
Plumbing education, information, advice, help and suggestions are provided by some of the most experienced plumbers who wish to "give back" to society. Since 1996 we have been the best online (strictly) PLUMBING advice site. If you have questions about plumbing, toilets, sinks, faucets, drains, sewers, water filters, venting, water heating, showers, pumps, and other strictly PLUMBING related issues then you've come to the right place. Please refrain from asking or discussing legal questions, or pricing, or where to purchase products, or any business issues, or for contractor referrals, or any other questions or issues not specifically related to plumbing. Keep all posts positive and absolutely no advertising. Our site is completely free, without ads or pop-ups and we don't tract you. We absolutely do not sell your personal information. We are made possible by:
Author:
broton (NY)
So I just replaced the two faucet "knob" cartridges for both the hot and the cold valves. It was a real pain in the butt... old knobs, hard to get off, etc. Any who... guess what? I'm done. Except I realize that I put the HOT one in the cold side, and the COLD one in the HOT side. Does it really matter? Beyond the direction you turn the knob to let the water flow? I don't think so... but am not sure. So I ask you fine folk.
I can understand you'd need to label the packages somehow so you know which direction each cartridges turns, and I assume just calling one HOT and the other COLD makes sense, or is easy. The only other reason I could see is if a gasket inside each is made specifically to handle HOT or COLD water. But I think that's overthinking this...
Help! and thank you.
-Z
|
Post Reply
|
Author:
packy (MA)
other than the direction the turn on/off, there is no difference.
a little grease on the end of the stem will keep the handles from sticking so badly next time.
|
Post Reply
|
Author:
mike45plus (CT)
Z,
Traditionally, all hot water stems on spread ( seperate hot & cold valves / handles) faucets open counter clockwise and close clockwise - that includes round, cross ( like a t or x ), or blade ( aka lever or wing ) handles.
Cold valves / stems that have handles that are round or cross, should open counter clockwise and close clockwise just like all hot faucets, however, cold faucets with blade or wing handles should open clockwise and close counter clockwise - for instance, on a faucet set with wing or blade handles both hot and cold will turn towards the spout to open, and away from the spout to close...........
|
Post Reply
|
Author:
hj (AZ)
That is true for "main line" faucets, but NOT necessarily so for "specialty" lines such as Santec, etc. They usually send ALL faucets with stems for lever faucets, regardless of whether you also purchase "round handles" or not. Sometimes changing a stem from hot to cold, or vice versa, is simply a matter or rotating the stem, cartridge, or clip.
|
Post Reply
|
Please note:
- Inappropriate messages or blatant advertising will be deleted. We cannot be held responsible for bad or inadequate advice.
- Plbg.com has no control over external content that may be linked to from messages posted here. Please follow external links with caution.
- Plbg.com is strictly for the exchange of plumbing related advice and NOT to ask about pricing/costs, nor where to find a product (try Google), nor how to operate or promote a business, nor for ethics (law) and the like questions.
- Plbg.com is also not a place to ask radiant heating (try HeatingHelp.com), electrical or even general construction type questions. We are exclusively for plumbing questions.
Search for plumbing parts on our sponsor's site:
Special thanks to our sponsor:
|