Over 698,000 strictly plumbing related posts
Plumbing education, information, advice, help and suggestions are provided by some of the most experienced plumbers who wish to "give back" to society. Since 1996 we have been the best online (strictly) PLUMBING advice site. If you have questions about plumbing, toilets, sinks, faucets, drains, sewers, water filters, venting, water heating, showers, pumps, and other strictly PLUMBING related issues then you've come to the right place. Please refrain from asking or discussing legal questions, or pricing, or where to purchase products, or any business issues, or for contractor referrals, or any other questions or issues not specifically related to plumbing. Keep all posts positive and absolutely no advertising. Our site is completely free, without ads or pop-ups and we don't tract you. We absolutely do not sell your personal information. We are made possible by:
Author:
airsense00 (MI)
New to plumbing. Should I cut this off below the 90 or heat it up?
Edited 1 times.
|
Post Reply
|
Author:
packy (MA)
you gotta have some soldering skills to do that one.
you may be able to locate and buy an exact replacement. then canabalize the new valve using all the parts to rebuild the old. it has to be exact. same brand etc.
|
Post Reply
|
Author:
airsense00 (MI)
I would replace the parts but when I went to take the front nut off the spigot it snapped right off, it is stuck, plus the thing leaks like crazy. I've never soldered before but I've seen it done. I was thinking of cutting it right below the 90 and raising the incoming pipe a little.
|
Post Reply
|
Author:
KCRoto (MO)
I would sweat the sillcock off first, then desolder the lower 90, or the pipe from it. Keep fire protection handy ALWAYS! If you properly clean and flux your joints, it should be fairly simple as long as the water isn't still dripping through. Water leaking through the pipes will make the joint fail 100% of the time.
|
Post Reply
|
Author:
m & m (MD)
"...I've never soldered before but I've seen it done..."
Best of luck with three sides of wood kindling nearby. Why not opt for a SharkBite and change over to plastic?
|
Post Reply
|
Please note:
- Inappropriate messages or blatant advertising will be deleted. We cannot be held responsible for bad or inadequate advice.
- Plbg.com has no control over external content that may be linked to from messages posted here. Please follow external links with caution.
- Plbg.com is strictly for the exchange of plumbing related advice and NOT to ask about pricing/costs, nor where to find a product (try Google), nor how to operate or promote a business, nor for ethics (law) and the like questions.
- Plbg.com is also not a place to ask radiant heating (try HeatingHelp.com), electrical or even general construction type questions. We are exclusively for plumbing questions.
Search for plumbing parts on our sponsor's site:
Special thanks to our sponsor: