Over 700,000 strictly plumbing related posts
Welcome to Plbg.com (also known as PlumbingForum.com) where plumbing advice, education, information, help and suggestions are provided by some of the most experienced plumbers and plumbing contractors anywhere who all wish to "give back" to society. Since 1996 we have been free without popup or other invasive ads and known to be the best online STRICTLY PLUMBING advice site. If you have questions about plumbing, toilets, sinks, faucets, drains, sewers, water filters, venting, water heating, showers, pumps, and other strictly PLUMBING related issues then you've come to the right place. Please refrain from asking or discussing legal questions, or pricing, or where to find and/or purchase products, or any business issues, or for contractor referrals, or any other questions or issues not specifically related to plumbing. Keep all posts positive and absolutely no advertising. Our site is completely free, without ads or pop-ups and we don't track you. We absolutely do not sell your personal information. We are made possible by:
Author:
jonath24 (CT)
I need to service a Symmons shower valve because it is leaking. It is 40 years old. It is quite amazing that it has been working for 40 years without any problem until now.
As always, the most difficult part of the job is to open the valve. I have 2 issues.
(1) The handle is stuck. The handle is made of metal. It is stuck to the spindle. I have tried a Faucet Handle and Sleeve Puller. It does not work because it is so stuck.
(2) Then I thought I wanted to remove the cap without removing the handle first. I cut the dome cover to expose the cap and was able to slide a wrench to engage the cap. Unfortunately, the cap is also stuck. I did not want to apply too large a force because I worried that I may damage the pipework behind.
What would be my options here?
In Youtube, I saw people twisting the handle to break the attached spindle. I suppose I can do that, but I am so worried of being not able to open the cap.
What is the best way to open the cap? Should I apply penetrating oil? Should I try an impact driver? I have both, but I am so worried.
In the worst case, I suppose I have to open up the wall if I have to replace the whole valve. Is there any alternative of servicing or replacing?
Thanks in advance.
|
Post Reply
|
Author:
george 7941 (Canada)
You could try pulling the handle with the puller after using a propane torch to heat up the handle splines whre it engages the shaft. Repeated heating and application of penetrating oil (I use Liquid Wrench) will help.
After the handle is off, a strong impact wrench shoud get the nut off.
|
Post Reply
|
Author:
packy (MA)
there is a screw behind that little button.
also call 1 800 SYMMONS for free advice and free parts.
|
Post Reply
|
Please note:
- Inappropriate messages or blatant advertising will be deleted. We cannot be held responsible for bad or inadequate advice.
- Plbg.com has no control over external content that may be linked to from messages posted here. Please follow external links with caution.
- Plbg.com is strictly for the exchange of plumbing related advice and NOT to ask about pricing/costs, nor where to find a product (try Google), nor how to operate or promote a business, nor for ethics (law) and the like questions.
- Plbg.com is also not a place to ask radiant heating (try HeatingHelp.com), electrical or even general construction type questions. We are exclusively for plumbing questions.
Search for plumbing parts on our sponsor's site:
Special thanks to our sponsor:
|