Welcome to Plbg.com
Thank you to all the plumbing professionals who offer their advice and expertise

Over 698,000 strictly plumbing related posts

Plumbing education, information, advice, help and suggestions are provided by some of the most experienced plumbers who wish to "give back" to society. Since 1996 we have been the best online (strictly) PLUMBING advice site. If you have questions about plumbing, toilets, sinks, faucets, drains, sewers, water filters, venting, water heating, showers, pumps, and other strictly PLUMBING related issues then you've come to the right place. Please refrain from asking or discussing legal questions, or pricing, or where to purchase products, or any business issues, or for contractor referrals, or any other questions or issues not specifically related to plumbing. Keep all posts positive and absolutely no advertising. Our site is completely free, without ads or pop-ups and we don't tract you. We absolutely do not sell your personal information. We are made possible by:  

Post New
Search
Log In
How to Show Images
Newest Subjects
 Standard practice to replace rubber no-hub seals?
Author: ihatedrips (CA)

I hired a plumber to correct the slope on my 3" cast iron drain line. The pipes and no-hub couplings are several decades old.



He did fix the slope, but since he did not have new couplings on hand, he reused the old rubber. He also tightened some of the screws with an impact driver instead of the standard 60-80 in-lb no-hub torque wrench. I see a little bit of water seeping out from the joints now and I am concerned that this repair will not last very long.

My gut feeling is that years-old rubber seals/gaskets should always be replaced after taking something apart, because they'll never be 100% watertight again. But I'd like to see what the experts say. Is it standard practice to always replace them in this situation, or is it common to reuse the old hardware?

Post Reply

 Re: Standard practice to replace rubber no-hub seals?
Author: Curly (CA)

I have never re-used a no-hub coupling. A lot of the time I slice the rubber part so I can peel them off.

I have used an impact driver to tighten them, but always finish up with the torque wrench.

To re-use one, then have it leak, then have to re-do the job ? Not worth it in my book.

Post Reply

 Re: Standard practice to replace rubber no-hub seals?
Author: bernabeu (SC)

You 'hired' a plumber.

You paid a shoemaker.

The 'rubbers' are NEVER reused.

The screws MUST be torqued.

==============================================

"Measure Twice & Cut Once" - Retired U.A. Local 1 & 638

Post Reply





Please note:
  • Inappropriate messages or blatant advertising will be deleted. We cannot be held responsible for bad or inadequate advice.
  • Plbg.com has no control over external content that may be linked to from messages posted here. Please follow external links with caution.
  • Plbg.com is strictly for the exchange of plumbing related advice and NOT to ask about pricing/costs, nor where to find a product (try Google), nor how to operate or promote a business, nor for ethics (law) and the like questions.
  • Plbg.com is also not a place to ask radiant heating (try HeatingHelp.com), electrical or even general construction type questions. We are exclusively for plumbing questions.

Search for plumbing parts on our sponsor's site:




Special thanks to our sponsor:
PlumbingSupply.com


Copyright© 2024 Plbg.com. All Rights Reserved.