Welcome to Plbg.com
Thank you to all the plumbing professionals who offer their advice and expertise

Over 698,000 strictly plumbing related posts

Plumbing education, information, advice, help and suggestions are provided by some of the most experienced plumbers who wish to "give back" to society. Since 1996 we have been the best online (strictly) PLUMBING advice site. If you have questions about plumbing, toilets, sinks, faucets, drains, sewers, water filters, venting, water heating, showers, pumps, and other strictly PLUMBING related issues then you've come to the right place. Please refrain from asking or discussing legal questions, or pricing, or where to purchase products, or any business issues, or for contractor referrals, or any other questions or issues not specifically related to plumbing. Keep all posts positive and absolutely no advertising. Our site is completely free, without ads or pop-ups and we don't tract you. We absolutely do not sell your personal information. We are made possible by:  

Post New
Search
Log In
How to Show Images
Newest Subjects
 Well pump pressure switch short cycling due to low pressure at pressure tank,
Author: ukiltmybrutha (VA)

Hi,

I recently received an alert from my Sense Monitoring system that the well pump had run for more than hours.

I could find no evidence of that and the next day I went to grab a glass of water and it tasted like salt water.

I am not very well versed with my water filtration system that has 4 components but I know that it has a brine tank with 3 other 5 footish high tanks that connect to each other.

The brine tank was low on salt and the tank next to it was running (water sounds) non stop.

I looked at the gauge at the well pressure switch near the pressure tank which is set for 63 high and 43 low. It would short cycle e.g. jump from 43 psi to 75 psi really quick back and forth.

I did some reading about checking the pressure tank psi. I checked the pressure and it was only at 9.5 psi after emptying it of water

I filled up the 10.5 year old pressure tank to about 38 psi (I know it should technically be 41 psi but didn't know that pressure switch was set to 43/63 psi until later).

Any ideas what would cause a leak in this case?

The unit is a ProFlo 32 gallon PF-32.

Thanks for any pointers.

Post Reply

 Re: Well pump pressure switch short cycling due to low pressure at pressure tank,
Author: bernabeu (SC)

old age

if it happens again (loss of air charge) replace it

==============================================

"Measure Twice & Cut Once" - Retired U.A. Local 1 & 638

Post Reply





Please note:
  • Inappropriate messages or blatant advertising will be deleted. We cannot be held responsible for bad or inadequate advice.
  • Plbg.com has no control over external content that may be linked to from messages posted here. Please follow external links with caution.
  • Plbg.com is strictly for the exchange of plumbing related advice and NOT to ask about pricing/costs, nor where to find a product (try Google), nor how to operate or promote a business, nor for ethics (law) and the like questions.
  • Plbg.com is also not a place to ask radiant heating (try HeatingHelp.com), electrical or even general construction type questions. We are exclusively for plumbing questions.

Search for plumbing parts on our sponsor's site:




Special thanks to our sponsor:
PlumbingSupply.com


Copyright© 2024 Plbg.com. All Rights Reserved.