Over 698,000 strictly plumbing related posts
Plumbing education, information, advice, help and suggestions are provided by some of the most experienced plumbers who wish to "give back" to society. Since 1996 we have been the best online (strictly) PLUMBING advice site. If you have questions about plumbing, toilets, sinks, faucets, drains, sewers, water filters, venting, water heating, showers, pumps, and other strictly PLUMBING related issues then you've come to the right place. Please refrain from asking or discussing legal questions, or pricing, or where to purchase products, or any business issues, or for contractor referrals, or any other questions or issues not specifically related to plumbing. Keep all posts positive and absolutely no advertising. Our site is completely free, without ads or pop-ups and we don't tract you. We absolutely do not sell your personal information. We are made possible by:
Author:
Eraserhead187 (IN)
Hi all,
We have 2 water heater tanks. One siphons energy off the geothermal to preheat, then is plumbed to the main electric unit. It's an AO Smith I believe, 80 or so gallons. It's one that is no longer available due to its capacity. Had no hot water the other day, so I went down and sure enough it was tripped on the unit. So I reset it, it fired up, and things were okay. It happened once again, reset, fine. However, it is now in this cycle where it gets the water scaldingly hot and then trips itself. I can reset it and it fires back up, but the water gets far too hot. I'm no expert, but I would imagine that it is shutting itself off due to the excessive temperatur with a safety mechanism.
Clearly it needs replaced, right? However, we are a family of 5 that uses a lot of hot water. What would be a suitable replacement option that wouldn't require me to replace one big tank with two smaller ones? I can certainly do without having 3 water heaters.
Thank you!!
|
Post Reply
|
Author:
steve (CA)
You might just need a thermostat replaced and not the entire heater.
|
Post Reply
|
Author:
bernabeu (SC)
ditto
read the manual
the mfgr WILL (MUST) send you one upon request
==============================================
"Measure Twice & Cut Once" - Retired U.A. Local 1 & 638
|
Post Reply
|
Author:
packy (MA)
exactly... just call an electrician to troubleshoot the wiring and to replace whichever component is giving you trouble.
|
Post Reply
|
Author:
hj (AZ)
You have at least one burned out element. Call a plumber to check the heater and repair it.
|
Post Reply
|
Please note:
- Inappropriate messages or blatant advertising will be deleted. We cannot be held responsible for bad or inadequate advice.
- Plbg.com has no control over external content that may be linked to from messages posted here. Please follow external links with caution.
- Plbg.com is strictly for the exchange of plumbing related advice and NOT to ask about pricing/costs, nor where to find a product (try Google), nor how to operate or promote a business, nor for ethics (law) and the like questions.
- Plbg.com is also not a place to ask radiant heating (try HeatingHelp.com), electrical or even general construction type questions. We are exclusively for plumbing questions.
Search for plumbing parts on our sponsor's site:
Special thanks to our sponsor:
|