Over 698,000 strictly plumbing related posts
Plumbing education, information, advice, help and suggestions are provided by some of the most experienced plumbers who wish to "give back" to society. Since 1996 we have been the best online (strictly) PLUMBING advice site. If you have questions about plumbing, toilets, sinks, faucets, drains, sewers, water filters, venting, water heating, showers, pumps, and other strictly PLUMBING related issues then you've come to the right place. Please refrain from asking or discussing legal questions, or pricing, or where to purchase products, or any business issues, or for contractor referrals, or any other questions or issues not specifically related to plumbing. Keep all posts positive and absolutely no advertising. Our site is completely free, without ads or pop-ups and we don't tract you. We absolutely do not sell your personal information. We are made possible by:
Author:
Vs1dcolor (CA)
I thought it was supposed to use an allen wrench to take off my handle, but it seems like there isn't the set screw that I'm not used to. Looks like it has a rod in the middle of it when I took a picture of the hole. Looks like a round tube that has a rod in the middle of it so my Allen wrench can't go in that hole. Any thoughts??
Edited 3 times.
|
Post Reply
|
Author:
bernabeu (SC)
need a larger in focus picture
==============================================
"Measure Twice & Cut Once" - Retired U.A. Local 1 & 638
|
Post Reply
|
Author:
NP16 (OR)
Looks like you need an Allen wrench tool.
These set screws are very easily stripped. So make sure the tool is completely inserted into the head of the screw before applying moderate force counter clockwise.
|
Post Reply
|
Author:
steve (CA)
That allen screw looks like it's at least partially stripped.
|
Post Reply
|
Author:
sharp1 (IL)
That appears to be a tamper resistant set screw that requires a special bit. The bit will have the hex shape on the outside and a hollow center that allows it to be inserted.
[www.amazon.com]
|
Post Reply
|
Author:
hj (AZ)
Unless it was done "after market" those screws have never been used in ANY faucet. How about a faucet number so we can look at a schematic.
|
Post Reply
|
Please note:
- Inappropriate messages or blatant advertising will be deleted. We cannot be held responsible for bad or inadequate advice.
- Plbg.com has no control over external content that may be linked to from messages posted here. Please follow external links with caution.
- Plbg.com is strictly for the exchange of plumbing related advice and NOT to ask about pricing/costs, nor where to find a product (try Google), nor how to operate or promote a business, nor for ethics (law) and the like questions.
- Plbg.com is also not a place to ask radiant heating (try HeatingHelp.com), electrical or even general construction type questions. We are exclusively for plumbing questions.
Search for plumbing parts on our sponsor's site:
Special thanks to our sponsor: