Over 698,000 strictly plumbing related posts
Plumbing education, information, advice, help and suggestions are provided by some of the most experienced plumbers who wish to "give back" to society. Since 1996 we have been the best online (strictly) PLUMBING advice site. If you have questions about plumbing, toilets, sinks, faucets, drains, sewers, water filters, venting, water heating, showers, pumps, and other strictly PLUMBING related issues then you've come to the right place. Please refrain from asking or discussing legal questions, or pricing, or where to purchase products, or any business issues, or for contractor referrals, or any other questions or issues not specifically related to plumbing. Keep all posts positive and absolutely no advertising. Our site is completely free, without ads or pop-ups and we don't tract you. We absolutely do not sell your personal information. We are made possible by:
Author:
Godammit (LA)
1 1/2 inch galvanized nipple is stuck at well pump. 20 min of torch aimed on female end (elbow) and still nothing. Have a 24” pipe wrench.
Edited 1 times.
|
Post Reply
|
Author:
bsipps (PA)
I have been successful cutting the nipple at threads then using the tiny Tim mini hacksaw to cut and pry out the threads from the fitting, or lots of wd40 and an hour or 2 wait time then try to unscrew
Edited 1 times.
|
Post Reply
|
Author:
bernabeu (SC)
need a 36 or larger pipe wrench for 'old' 1-1/2
==============================================
"Measure Twice & Cut Once" - Retired U.A. Local 1 & 638
|
Post Reply
|
Author:
hj (AZ)
Or my 48" compound wrench.
|
Post Reply
|
Author:
bernabeu (SC)
? should i bother trying to describe how to use a sawz-all followed by a 'cape chisel' after 'notching' the internal threads ?
for the OP:
cut the 1-1/2 flush with the fitting face
insert the sawz-all blade into the fitting and cut (notch) the remaining threads of the pipe juuuussssst short of cutting the threads of the fitting itself
be patient and LOOK often
use the chisel to 'fold in' the pipe starting near the 'slice' you made
once it BEGINS to fold the 'grip' is lost and it WILL unscew by hand with a pair of pliers
about 15 minutes total
==============================================
"Measure Twice & Cut Once" - Retired U.A. Local 1 & 638
Edited 1 times.
|
Post Reply
|
Author:
Don411 (IN)
I've used that process also, but it depends on where the fitting is...if it's in a trench or hole in the ground that's gonna be tough. I would be inclined to add a pipe on the handle of the 24" wrench and try to muscle it off, and save the cut/fold as a last resort.
|
Post Reply
|
Please note:
- Inappropriate messages or blatant advertising will be deleted. We cannot be held responsible for bad or inadequate advice.
- Plbg.com has no control over external content that may be linked to from messages posted here. Please follow external links with caution.
- Plbg.com is strictly for the exchange of plumbing related advice and NOT to ask about pricing/costs, nor where to find a product (try Google), nor how to operate or promote a business, nor for ethics (law) and the like questions.
- Plbg.com is also not a place to ask radiant heating (try HeatingHelp.com), electrical or even general construction type questions. We are exclusively for plumbing questions.
Search for plumbing parts on our sponsor's site:
Special thanks to our sponsor: