Welcome to Plbg.com
Thank you to all the plumbing professionals who offer their advice and expertise

Over 675,000 strictly plumbing related posts

Welcome to Plbg.com and PlumbingForum.com. The best online (strictly) PLUMBING advice, help, dyi, and informational plumbing forum. Questions and discussions about toilets, sinks, faucets, drainage, venting, water heating, showers, pumps, water quality, and other exclusively PLUMBING related issues. Please refrain from asking where to purchase a product, or business, pricing, or legal questions, or for contractor referrals, or any questions not related to plumbing. Keep all posts positive and absolutely no advertising. Our site is completely free, without ads or pop-ups. We do not sell your information. We are made possible by:  

Post New
Search
Log In
How to Show Images
Newest Subjects
 Sump discharge pipes in masonry foundation
Author: Monkey Wrench (PA)

So, I am correcting an issue with the discharge pipes from the sump pumps. Two regular sump pumps share a single 1.5" discharge pipe. I am changing that to two (or maybe three for the battery back up). Does it matter where the discharge pipe exits through the masonry? It is presently exiting through the bottom of the top layer of block and top of the next layer down. The top layer is not solid block, but hollow. The house is in PA. Any code issues to be aware of?

Thanks!

Post Reply

 Re: Sump discharge pipes in masonry foundation
Author: packy (MA)

battery back up sump pumps usually discharge into the same pipe as the 110V pump.
there are no code issues that i am aware of.

Post Reply

 Re: Sump discharge pipes in masonry foundation
Author: bsipps (PA)

I personally would not install 2 regular sump pumps on the same line, on the other hand it is normal to install a main sump pump in line with an emergency battery back up pump

Post Reply

 Re: Sump discharge pipes in masonry foundation
Author: Monkey Wrench (PA)

Right, because if both pumps are working at the same time, each is working at half efficiency due to sharing the discharge pipe. The battery back up having its own discharge pipe reduces the risk of check valve failure, and that is the preferred method of installation per the instructions. My other question is there a preferred method of running the discharge pipe through the masonry? Normally the top layer of block should be solid, but that isn't the case on this job. This one goes through the wall and then downhill. The lower the pipe exits the house, the less work the pumps need to do.

Post Reply





Please note:
  • Inappropriate messages or blatant advertising will be deleted. We cannot be held responsible for bad or inadequate advice.
  • Plbg.com has no control over external content that may be linked to from messages posted here. Please follow external links with caution.
  • Plbg.com is strictly for the exchange of plumbing related advice and NOT to ask about pricing/costs, nor where to find a product (try Google), nor how to operate or promote a business, nor for ethics (law) and the like questions.
  • Plbg.com is also not a place to ask radiant heating (try HeatingHelp.com), electrical or even general construction type questions. We are exclusively for plumbing questions.

Search for plumbing parts on our sponsor's site:




Special thanks to our sponsor:
PlumbingSupply.com


Copyright© 2021 Plbg.com. All Rights Reserved.