Over 698,000 strictly plumbing related posts
Plumbing education, information, advice, help and suggestions are provided by some of the most experienced plumbers who wish to "give back" to society. Since 1996 we have been the best online (strictly) PLUMBING advice site. If you have questions about plumbing, toilets, sinks, faucets, drains, sewers, water filters, venting, water heating, showers, pumps, and other strictly PLUMBING related issues then you've come to the right place. Please refrain from asking or discussing legal questions, or pricing, or where to purchase products, or any business issues, or for contractor referrals, or any other questions or issues not specifically related to plumbing. Keep all posts positive and absolutely no advertising. Our site is completely free, without ads or pop-ups and we don't tract you. We absolutely do not sell your personal information. We are made possible by:
Author:
gj13us (PA)
I have a Delta single handle pull-out kitchen faucet. It drips. I want to remove the handle to see if there's a piece inside that can be tightened or maybe I have to replace the cartridge. The hex set screw behind the plastic blue/red Delta badge is frozen. It won't budge. I've tried tapping with a hammer.
Any ideas on how to remove it? I don't want to strip it too much. Saturate with CLR/Lime Away?
|
Post Reply
|
Author:
srloren (CA)
WD-40 let it soak over night
|
Post Reply
|
Author:
gj13us (PA)
Propane? Or blow dryer? I.e., how hot?
|
Post Reply
|
Author:
gj13us (PA)
Re: WD-40. Thank you.
|
Post Reply
|
Author:
packy (MA)
hair dryer won't do it.
the trick is to use a torch and get it hot enough to loosen the corrosion.
plan on getting a complete rebuild kit as the heat may damage some of the seals. they are completely replaceable.
sponsor sells this one.
|
Post Reply
|
Author:
srloren (CA)
Were you able to replace the worn parts?
|
Post Reply
|
Author:
120volts (CA)
PB Blaster is much better than WD-40 at unfreezing bolts.
|
Post Reply
|
Author:
gj13us (PA)
Haven't had a chance to work on it since I posted.
|
Post Reply
|
Author:
Paul48 (CT)
Make sure the Allen wrench you use does not have a ball-driver on the end. It will snap off in the set screw, and the you're "up a creek". If you can reach it with the tip of a soldering gun you might do less damage.
|
Post Reply
|
Please note:
- Inappropriate messages or blatant advertising will be deleted. We cannot be held responsible for bad or inadequate advice.
- Plbg.com has no control over external content that may be linked to from messages posted here. Please follow external links with caution.
- Plbg.com is strictly for the exchange of plumbing related advice and NOT to ask about pricing/costs, nor where to find a product (try Google), nor how to operate or promote a business, nor for ethics (law) and the like questions.
- Plbg.com is also not a place to ask radiant heating (try HeatingHelp.com), electrical or even general construction type questions. We are exclusively for plumbing questions.
Search for plumbing parts on our sponsor's site:
Special thanks to our sponsor: