Over 698,000 strictly plumbing related posts
Plumbing education, information, advice, help and suggestions are provided by some of the most experienced plumbers who wish to "give back" to society. Since 1996 we have been the best online (strictly) PLUMBING advice site. If you have questions about plumbing, toilets, sinks, faucets, drains, sewers, water filters, venting, water heating, showers, pumps, and other strictly PLUMBING related issues then you've come to the right place. Please refrain from asking or discussing legal questions, or pricing, or where to purchase products, or any business issues, or for contractor referrals, or any other questions or issues not specifically related to plumbing. Keep all posts positive and absolutely no advertising. Our site is completely free, without ads or pop-ups and we don't tract you. We absolutely do not sell your personal information. We are made possible by:
Author:
alexddyang (Canada)
Hi,
I am replacing my 25 yr old radiant floor hydronic boiler.
Because my piping for the floor heating is poly-b, my heating company recommends a isolation heat exchanger, to create two isolated loops (a “floor loop” with old poly-b pipes and a much shorter “boiler loop” with new piping). As poly-b lets in oxygen, this will keep the oxygenated water within the floor loop, protecting the new boiler from rust.
But in addition, they also recommended a “Side Stream Water Filter” for the floor loop. Saying that if the poly-b is still corroding something, the filter will at least catch the debris or rust particles etc. But I am already getting new stainless steel pumps and heat exchanger for the floor loop, and my poly-b fittings are all copper, so I wonder what else could still be corroded in that loop?
In short, I wonder if the side stream water filter is worthwhile to get. Please let me know your opinions.
|
Post Reply
|
Author:
packy (MA)
sounds like you are getting good advice.
i too think the filter would not be needed.
setting up the floor circuits so there is absolutely no iron nor steel piping is enough.
run 190-200 F deg water from the boiler to the heat exchanger.
set the mixing valve from the heat exchanger to the floor circuits to 125 F deg and you should be fine.
make sure there is a good thermometer in the feed pipe to the infloor heating.
depending on how much piping there is in the floor and how close the pipes are to eachother and the outside temperature, you may have to play with the temperature water going to the floor for maximum comfort.
the circulator for the infloor piping needs to be stainless but the boiler circulator can be a cast iron 3 speed grundfos (or equivalent).
|
Post Reply
|
Please note:
- Inappropriate messages or blatant advertising will be deleted. We cannot be held responsible for bad or inadequate advice.
- Plbg.com has no control over external content that may be linked to from messages posted here. Please follow external links with caution.
- Plbg.com is strictly for the exchange of plumbing related advice and NOT to ask about pricing/costs, nor where to find a product (try Google), nor how to operate or promote a business, nor for ethics (law) and the like questions.
- Plbg.com is also not a place to ask radiant heating (try HeatingHelp.com), electrical or even general construction type questions. We are exclusively for plumbing questions.
Search for plumbing parts on our sponsor's site:
Special thanks to our sponsor:
|