Over 698,000 strictly plumbing related posts
Plumbing education, information, advice, help and suggestions are provided by some of the most experienced plumbers who wish to "give back" to society. Since 1996 we have been the best online (strictly) PLUMBING advice site. If you have questions about plumbing, toilets, sinks, faucets, drains, sewers, water filters, venting, water heating, showers, pumps, and other strictly PLUMBING related issues then you've come to the right place. Please refrain from asking or discussing legal questions, or pricing, or where to purchase products, or any business issues, or for contractor referrals, or any other questions or issues not specifically related to plumbing. Keep all posts positive and absolutely no advertising. Our site is completely free, without ads or pop-ups and we don't tract you. We absolutely do not sell your personal information. We are made possible by:
Author:
chinagirl (WY)
First, I'm a total amateur. I decided to install a new bathroom sink faucet. I don't have shut-off valves under the sink counter, so went to the closet where the hot water heater is located as well as the valve to the whole house, and turned off the water to the house. Once i was finished in the bathroom I turned the house water valve back on and went to check the new faucet. All's good. Then I went back to close the door to the hot water heater and found water on the floor! The copper hose with hot water was leaking from the top of the hot water heater (and, of course, it's Saturday evening.... *sigh*). I've turned the water to the house back off. What happened? Can I fix this tomorrow or do I need to call a plumber. I repeat - I am a total amateur, I'm just a do it yourselfer... help?
|
Post Reply
|
Author:
steve (CA)
Try tightening the nut. There's a rubber washer in there that might need to be replaced.
|
Post Reply
|
Author:
chinagirl (WY)
Yup - that did it. So that was such a simple temporary fix, and I thank you for suggesting I have the rubber seal replaced. Thanks as well for such a prompt reply!
|
Post Reply
|
Author:
chinagirl (WY)
I am so impressed.
I tried looking at older posts before posting myself and noticed that you are often the one that helps. Not sure if anyone lets you know just how appreciated you really are.
Edited 1 times.
|
Post Reply
|
Author:
hi (TX)
Steve is very helpful. When you have a problem like this the best way many times has to post a picture of what you have so that are plumbers can identify the problem they're usually able to give you a better help. Next line the once it stopped leaking is probably no need to replace the Rubber seal if you tighten
Edited 1 times.
|
Post Reply
|
Author:
srloren (CA)
ChinaGirl, sometimes when you turn off the valve to the water heater, the movement of that valve and/or piping can disturb the seal at those rubber seals and cause a tiny leak, maybe only a few drips per day. So after installing a new water heater it pays to go back and check for those potential leaks. This is good practice and can save a call back by your plumber. I will add that depending on your water chemistry, you can sometimes see minerals working its way through that seal and attacking the metal nipples thus giving you a hint of a problem. Good luck... Loren Sr
Edited 1 times.
|
Post Reply
|
Please note:
- Inappropriate messages or blatant advertising will be deleted. We cannot be held responsible for bad or inadequate advice.
- Plbg.com has no control over external content that may be linked to from messages posted here. Please follow external links with caution.
- Plbg.com is strictly for the exchange of plumbing related advice and NOT to ask about pricing/costs, nor where to find a product (try Google), nor how to operate or promote a business, nor for ethics (law) and the like questions.
- Plbg.com is also not a place to ask radiant heating (try HeatingHelp.com), electrical or even general construction type questions. We are exclusively for plumbing questions.
Search for plumbing parts on our sponsor's site:
Special thanks to our sponsor:
|