Over 698,000 strictly plumbing related posts
Plumbing education, information, advice, help and suggestions are provided by some of the most experienced plumbers who wish to "give back" to society. Since 1996 we have been the best online (strictly) PLUMBING advice site. If you have questions about plumbing, toilets, sinks, faucets, drains, sewers, water filters, venting, water heating, showers, pumps, and other strictly PLUMBING related issues then you've come to the right place. Please refrain from asking or discussing legal questions, or pricing, or where to purchase products, or any business issues, or for contractor referrals, or any other questions or issues not specifically related to plumbing. Keep all posts positive and absolutely no advertising. Our site is completely free, without ads or pop-ups and we don't tract you. We absolutely do not sell your personal information. We are made possible by:
Author:
Bob Hand (MD)
I have a moen roman tub and want to replace the faucet and spout.
The 3/4" OD stem is to short to reach the gasket in the spout. Is the a way to extend the stem or other method to make it so the stem/spout does not leak?
|
Post Reply
|
Author:
North Carolina Plumber (NC)
The brass shank has most likely been cut too short. You're probably looking at either replacing the brass shank or finding another spout that doesn't require such a long shank. It will require access underneath the tub if you want to replace with a longer one.
|
Post Reply
|
Author:
Bob Hand (MD)
That's what I was afraid of. When they tiled the tub they did not install a access panel.
I don't want to tear the tile off because I can't replace just a section its to old.
Any other options that don't require access to below?
The spout fits far enough down on the stem so that the allen nut will secure it tightly. Just not far engh to go beyond the gasket
Edited 1 times.
|
Post Reply
|
Author:
hj (AZ)
I think you already know the answer. I have used a "multi tool" with a diamond blade to cut an opening in the tile, using the grout lines, to get under the tub. Then fasten the piece back in.
|
Post Reply
|
Author:
stuckinlodi (MO)
After you remove the tile to do the needed work install an access plate or panel. It may be needed again down the road, plus you won't have to worry about matching the old tile.
|
Post Reply
|
Please note:
- Inappropriate messages or blatant advertising will be deleted. We cannot be held responsible for bad or inadequate advice.
- Plbg.com has no control over external content that may be linked to from messages posted here. Please follow external links with caution.
- Plbg.com is strictly for the exchange of plumbing related advice and NOT to ask about pricing/costs, nor where to find a product (try Google), nor how to operate or promote a business, nor for ethics (law) and the like questions.
- Plbg.com is also not a place to ask radiant heating (try HeatingHelp.com), electrical or even general construction type questions. We are exclusively for plumbing questions.
Search for plumbing parts on our sponsor's site:
Special thanks to our sponsor: