Over 698,000 strictly plumbing related posts
Plumbing education, information, advice, help and suggestions are provided by some of the most experienced plumbers who wish to "give back" to society. Since 1996 we have been the best online (strictly) PLUMBING advice site. If you have questions about plumbing, toilets, sinks, faucets, drains, sewers, water filters, venting, water heating, showers, pumps, and other strictly PLUMBING related issues then you've come to the right place. Please refrain from asking or discussing legal questions, or pricing, or where to purchase products, or any business issues, or for contractor referrals, or any other questions or issues not specifically related to plumbing. Keep all posts positive and absolutely no advertising. Our site is completely free, without ads or pop-ups and we don't tract you. We absolutely do not sell your personal information. We are made possible by:
Author:
jea9star (TX)
4" PVC drain pipe, slightly misshaped from 1) not being installed properly to begin with and 2) from het gun trying to get the old broken flange out. I need to dry fit to make sure the new one fits properly but it's such a tight fit I'm afraid I wont be able to get it back out to then prime and cement it in place. I'm thinking I might need to heat both pieces with a heat gun to make the fittings more pliable and use a rubber mallet to get the flange into the drain pipe and all the down to the floor. If I use primer and glue, how much work time do I have?
Edited 1 times.
|
Post Reply
|
Author:
stuckinlodi (MO)
Seconds. I don't think I'd try it.
|
Post Reply
|
Author:
jea9star (TX)
Thats what I thought, should I just try to dry fit with no solvent (prime/glue)? I need a workable solution and quick, I have no toilet.
|
Post Reply
|
Author:
packy (MA)
i would sandpaper a little off the part of the flange that is being inserted into the pipe.
it is going inside so shaving it a little won't cause any harm..
|
Post Reply
|
Author:
stuckinlodi (MO)
that looks like a good solution.
|
Post Reply
|
Author:
sum (FL)
Do they have an push tite offset flange?
|
Post Reply
|
Author:
bernabeu (SC)
make CERTAIN the push-tite is secured to the subfloor ...................
==============================================
"Measure Twice & Cut Once" - Retired U.A. Local 1 & 638
|
Post Reply
|
Author:
Paul48 (CT)
How about one of those temporary plugs, that expands to seal the pipe. Put that in and heat the pipe.
|
Post Reply
|
Please note:
- Inappropriate messages or blatant advertising will be deleted. We cannot be held responsible for bad or inadequate advice.
- Plbg.com has no control over external content that may be linked to from messages posted here. Please follow external links with caution.
- Plbg.com is strictly for the exchange of plumbing related advice and NOT to ask about pricing/costs, nor where to find a product (try Google), nor how to operate or promote a business, nor for ethics (law) and the like questions.
- Plbg.com is also not a place to ask radiant heating (try HeatingHelp.com), electrical or even general construction type questions. We are exclusively for plumbing questions.
Search for plumbing parts on our sponsor's site:
Special thanks to our sponsor: