Over 698,000 strictly plumbing related posts
Plumbing education, information, advice, help and suggestions are provided by some of the most experienced plumbers who wish to "give back" to society. Since 1996 we have been the best online (strictly) PLUMBING advice site. If you have questions about plumbing, toilets, sinks, faucets, drains, sewers, water filters, venting, water heating, showers, pumps, and other strictly PLUMBING related issues then you've come to the right place. Please refrain from asking or discussing legal questions, or pricing, or where to purchase products, or any business issues, or for contractor referrals, or any other questions or issues not specifically related to plumbing. Keep all posts positive and absolutely no advertising. Our site is completely free, without ads or pop-ups and we don't tract you. We absolutely do not sell your personal information. We are made possible by:
Author:
sum (FL)
I have been trying to replace the pedestal sink (the old one cracked).
The new one is a Kohler Wellworth with a Kohler faucet.
However, after I put everything together (I haven't caulked anything yet), I noticed that I could lift the bowl by a very tiny amount, which causes the edge of the bowl to tilt every so slightly closer to the wall. I am talking about a very small amount, like 1/16".
I don't know what caused it. It could be the tiled floor is not level, or it could be that I drilled the two holes in the wall a tad too high?
Anyways, any suggestions?
(A) Too small an amount to worry about, caulk it and forget it.
( Lift the bowl up a little, slide a piece of roofing felt between the bowl and base and that should do it.
(C) Shim the front of the base up a tiny bit, then caulk around the base.
|
Post Reply
|
Author:
m & m (MD)
There were probably self-stick shims packed with the sink. Most manufacturers include them. They go between the bowl and pedestal as needed.
|
Post Reply
|
Author:
hj (AZ)
A, and quit overanalyzing EVERYTHING. Who REALLY lifts up on the front of a pedestal lav once it is mounted?
|
Post Reply
|
Author:
bernabeu (SC)
children
==============================================
"Measure Twice & Cut Once" - Retired U.A. Local 1 & 638
|
Post Reply
|
Author:
Paul48 (CT)
I'd use silicone caulk and take advantage of the adhesive qualities. It won't go anywhere.
|
Post Reply
|
Please note:
- Inappropriate messages or blatant advertising will be deleted. We cannot be held responsible for bad or inadequate advice.
- Plbg.com has no control over external content that may be linked to from messages posted here. Please follow external links with caution.
- Plbg.com is strictly for the exchange of plumbing related advice and NOT to ask about pricing/costs, nor where to find a product (try Google), nor how to operate or promote a business, nor for ethics (law) and the like questions.
- Plbg.com is also not a place to ask radiant heating (try HeatingHelp.com), electrical or even general construction type questions. We are exclusively for plumbing questions.
Search for plumbing parts on our sponsor's site:
Special thanks to our sponsor:
|