Over 698,000 strictly plumbing related posts
Plumbing education, information, advice, help and suggestions are provided by some of the most experienced plumbers who wish to "give back" to society. Since 1996 we have been the best online (strictly) PLUMBING advice site. If you have questions about plumbing, toilets, sinks, faucets, drains, sewers, water filters, venting, water heating, showers, pumps, and other strictly PLUMBING related issues then you've come to the right place. Please refrain from asking or discussing legal questions, or pricing, or where to purchase products, or any business issues, or for contractor referrals, or any other questions or issues not specifically related to plumbing. Keep all posts positive and absolutely no advertising. Our site is completely free, without ads or pop-ups and we don't tract you. We absolutely do not sell your personal information. We are made possible by:
Author:
member333 (CA)
Two weeks after I installed kitchen sink strainer(passed leak check), plumber putty started to get squeezed from kitchen sink strainer and this caused leak (at place where plumber putty seal between kitchen sink and strainer) . Nut which was very tight after installation became loose, so I can rotate it by hand .
Based on that , I can conclude that due to plumber putty get squeezed(for some reason),nut became loose and leak took place. Please suggest how to fix the leak. Thanks
|
Post Reply
|
Author:
packy (MA)
remove the putty and use 100% silicone caulk. tighten, clean up and use within a couple of minutes.
|
Post Reply
|
Author:
m & m (MD)
"... remove the putty and use 100% silicone caulk. tighten, clean up and use within a couple of minutes..."
Leakproof. Guaranteed.
|
Post Reply
|
Author:
packy (MA)
100% silicone is guaranteed 100% leakproof 100% of the time..
|
Post Reply
|
Author:
hj (AZ)
The installer did not remove the putty from under the sink when he installed the drain fitting. The putty got into the strainer's threads so it could not be tightened and eventually the strainer loosened up. Put the strainer back in with new putty, push it into the opening, "wipe" the excess putty off the bottom of the sink, then tighten the strainer.
|
Post Reply
|
Author:
Fixitangel (NC)
Yes, but fresh, warm plumber's putty is 100% more fun to knead and squish into place
If the putty is not pressed firmly into place and the excess removed as HJ says, when warm water heats up the basket strainer, that's when it will loosen up.
|
Post Reply
|
Please note:
- Inappropriate messages or blatant advertising will be deleted. We cannot be held responsible for bad or inadequate advice.
- Plbg.com has no control over external content that may be linked to from messages posted here. Please follow external links with caution.
- Plbg.com is strictly for the exchange of plumbing related advice and NOT to ask about pricing/costs, nor where to find a product (try Google), nor how to operate or promote a business, nor for ethics (law) and the like questions.
- Plbg.com is also not a place to ask radiant heating (try HeatingHelp.com), electrical or even general construction type questions. We are exclusively for plumbing questions.
Search for plumbing parts on our sponsor's site:
Special thanks to our sponsor:
|