Over 698,000 strictly plumbing related posts
Plumbing education, information, advice, help and suggestions are provided by some of the most experienced plumbers who wish to "give back" to society. Since 1996 we have been the best online (strictly) PLUMBING advice site. If you have questions about plumbing, toilets, sinks, faucets, drains, sewers, water filters, venting, water heating, showers, pumps, and other strictly PLUMBING related issues then you've come to the right place. Please refrain from asking or discussing legal questions, or pricing, or where to purchase products, or any business issues, or for contractor referrals, or any other questions or issues not specifically related to plumbing. Keep all posts positive and absolutely no advertising. Our site is completely free, without ads or pop-ups and we don't tract you. We absolutely do not sell your personal information. We are made possible by:
Author:
BigReg1500 (CT)
I'm helping someone do a bathroom and need to transition from 1.5" copper to pvc for a sink and tub drain. Would I be better off sweating a threaded adapter on each copper branch, or using a banded coupling for the transition?
The house is about 50 years old, so I don't want to have to chase the copper back any further than needed to find a solid enough section to make the transition.
Suggestions please? Thanks
Edited 1 times.
|
Post Reply
|
Author:
steve (CA)
I would use the shielded couplings.
|
Post Reply
|
Author:
BigReg1500 (CT)
I have a standard T torque wrench for the 5/16" band bolts. Does copper take a lower torque than pvc to avoid crushing the pipe?
|
Post Reply
|
Author:
hj (AZ)
No, and you can get a "copper to PVC" shielded/banded coupling so you do not need a threaded adapter. The couplings do not conform to a "thread" very well, any way.
|
Post Reply
|
Author:
BigReg1500 (CT)
Thanks, I initially meant should I go with a banded coupling or threaded adapter on the existing copper and a new one on the pvc.
Sounds like if the copper is sound I'll be OK with the copper to pvc coupling without crushing the pipe.
|
Post Reply
|
Author:
george 7941 (Canada)
When the OP mentioned "threaded adapter" I took it to mean FPT adapter on copper end and MPT adapter on PVC end and the two screwed together, with no banded coupling.
OP confirmed my supposition while I was typing it out.
Edited 1 times.
|
Post Reply
|
Author:
hj (AZ)
If a banded coupling EVER damaged a copper pipe when it was tightened, then the copper was "worn out" any way and had to be changed. And a threaded adapter would NOT have worked either.
Edited 1 times.
|
Post Reply
|
Please note:
- Inappropriate messages or blatant advertising will be deleted. We cannot be held responsible for bad or inadequate advice.
- Plbg.com has no control over external content that may be linked to from messages posted here. Please follow external links with caution.
- Plbg.com is strictly for the exchange of plumbing related advice and NOT to ask about pricing/costs, nor where to find a product (try Google), nor how to operate or promote a business, nor for ethics (law) and the like questions.
- Plbg.com is also not a place to ask radiant heating (try HeatingHelp.com), electrical or even general construction type questions. We are exclusively for plumbing questions.
Search for plumbing parts on our sponsor's site:
Special thanks to our sponsor:
|