Over 698,000 strictly plumbing related posts
Plumbing education, information, advice, help and suggestions are provided by some of the most experienced plumbers who wish to "give back" to society. Since 1996 we have been the best online (strictly) PLUMBING advice site. If you have questions about plumbing, toilets, sinks, faucets, drains, sewers, water filters, venting, water heating, showers, pumps, and other strictly PLUMBING related issues then you've come to the right place. Please refrain from asking or discussing legal questions, or pricing, or where to purchase products, or any business issues, or for contractor referrals, or any other questions or issues not specifically related to plumbing. Keep all posts positive and absolutely no advertising. Our site is completely free, without ads or pop-ups and we don't tract you. We absolutely do not sell your personal information. We are made possible by:
Author:
Bobrob33 (KY)
I perfectly squared my 2" pvc pipe, applied the primer and cement, then stuck on the coupling. It maybe got at best 2/3rds the way to the lip of the coupling. Then I had to freakin cut it off and now I have precious little space to work with when I try again (and I might not even have enough). What did I do wrong? Did I not push the coupling on hard enough? It looked like the coupling kept wanting to pop out. I'm so frustrated I want to break my tv lol. Thanks
Edited 1 times.
|
Post Reply
|
Author:
Mike980548 (MA)
When installing the PVC fitting turn it about a 1/2 turn as you push it on and then hold it in position for 30 seconds or so to allow the glue to set. Many times if too much glue is used, the fitting will actually push itself back like it is under pressure.
Good luck
Edited 1 times.
|
Post Reply
|
Author:
bernabeu (SC)
cut square
de-burr including outside
clean - prime pipe and fitting - apply solvent cement sparingly to fitting, copiously to pipe - insert pipe or attach fitting WHILE TWISTING at least 1/2 turn - hold for 30 sec to 1 min
the fittings are TAPERED to ensure pressure for solvent welding process - while the entire joint is 'glued' the 'bottom 1/2' will actually be 'welded' into forming a solid piece piece
==============================================
"Measure Twice & Cut Once" - Retired U.A. Local 1 & 638
|
Post Reply
|
Please note:
- Inappropriate messages or blatant advertising will be deleted. We cannot be held responsible for bad or inadequate advice.
- Plbg.com has no control over external content that may be linked to from messages posted here. Please follow external links with caution.
- Plbg.com is strictly for the exchange of plumbing related advice and NOT to ask about pricing/costs, nor where to find a product (try Google), nor how to operate or promote a business, nor for ethics (law) and the like questions.
- Plbg.com is also not a place to ask radiant heating (try HeatingHelp.com), electrical or even general construction type questions. We are exclusively for plumbing questions.
Search for plumbing parts on our sponsor's site:
Special thanks to our sponsor: