|
- over 450,000 plumbing related posts
The very popular general plumbing, toilets, sinks, faucets, pump problems, questions and answers discussion Forum
|
|
Author:
bawebfoot (WA)
Have a single lever kitchen fawcett. Good pressure on cold but the hot water side is low.Do I have a partial plugled hot water line ( old plumbing is galvanize ) or is the fawcett bad? Also have a hot water dispenser on the sink that the pressure is low too.
Edited 1 times.
|
 |
|
|
Author:
LemonPlumber (FL)
I would remove the supply line at the hot side shut off valve, place a bucket under it and turn it on with your hand over the outlet to check where the flow restriction is.
----
Good Luck. Insulate your hot piping, although costly, it will pay you back every day.
|
|
|
|
|
Author:
waukeshaplumbing (WI)
i usually find things jammed into the stop valve under the sink, or the supply tube..
take the valve off and clean/replace...then put the valve back on and run the water into a bucket until the rust stops
save for a repipe...a few thousand is typical
|
|
|
|
